by amnani.adnan | Dec 15, 2009 | Blog
Hey friends! Take a look on the figure below, here are two similar model with simple geometry, but when you take a closer look, you will notice there are a bit difference between this two models. As indicate in my picture, the ending face of the 1st model are normal... by amnani.adnan | Dec 11, 2009 | Blog
BOOOM~~ *APPEARing…*hiiyooooo~ Good days everyone.. finally, tyler here again. This is my latest work by SolidWorks, Ninja~~~For this ninja.. What i wanna share here is… Once we finish the modeling, we may do the appearances assignments in the SolidWorks... by amnani.adnan | Dec 8, 2009 | Blog, CCX, koenigsegg, Race car
Lots of time, I facing this question.” Er… can SolidWorks design car ar?” Most of them are ask for fun, some of them are waiting me to say no and say, “Cheh! your software also not powerful 1”. But sorry to disappoint them, my answer is... by amnani.adnan | Dec 8, 2009 | auto trace, Blog, christmas, cow
Haha! was thinking to design something special to hang on our x’mas tree in our office. It all start with a quick hand drafting and then I scan it, mooo~And with SolidWorks autotrace, I trace it and wah lah!~ this is what I get. Still thinking to 3D print it and... by amnani.adnan | Dec 5, 2009 | Blog
SolidWorks Surfacing ToolsHi friends, recently I am working with a customer who are designing model which need a lot of surfacing techniques, here I would like to share two simple surfacing commands with you guys which are very useful and save you a lot of time when...